Welcome to visit Changzhou Runhua Electric Co., Ltd. Official website!
TEL

0086-519-82305398

Current location:Home > Products > Water bath pot series > Stirring circulating water bath
PRODUCTS
  • Jj-4ab single case 6-hole water bath pan with stirring intelligent digital display temperature control and speed measurement high power electric stirring

Jj-4ab single case 6-hole water bath pan with stirring intelligent digital display temperature control and speed measurement high power electric stirring

Overview:Jj-4ab digital display constant temperature water bath pot asynchronous speed measurement electric stirring1、 Introduction:In order to meet the needs of laboratory staff, jj-4ab is based on the six synchronous stirring. Six agitators are separately s…

Consulting

Jj-4ab digital display constant temperature water bath pot asynchronous speed measurement electric stirring

1、 Introduction:

  In order to meet the needs of laboratory staff, jj-4ab is based on the six synchronous stirring. Six agitators are separately stirred, and a single 6-hole water bath pot works. The speed can be controlled independently and the speed can be measured by digital display. The joint manufacturing of six digital speed measurement electric agitators is formed. The design is reasonable and the structure is novel. The brushless DC motor is used, Stepless speed regulation, using advanced power amplifier circuit, has stable speed, high torque, low noise, intuitive speed display, simple and safe operation. It is an essential basic equipment for colleges and universities, scientific research units and chemical engineering units.


2、 Technical parameters:

Working power supply: 220V50 Hz
Asynchronous power: 100W * 6
Timing range: 0-120min
Speed regulation range: 0-3000r / min
Speed measurement range: start - 3000 rpm
Heating power: 1500W
Temperature control range: room temperature - 100 ℃
Heating mode: single case 6-hole constant temperature mixing with speed measurement


 

3、 How to use it

  First of all, support the mixing rod on the motor shaft clamp, and adjust the speed control knob to the lowest speed position, place the solution to be stirred in the center of the mixing bar, turn on the power switch, and select the required time or normally open when timing operation is required. If the stirred solution is dilute, the speed can be adjusted to 500 rpm. If the solution is viscous, the speed should be adjusted to 600-3000 rpm.

 

4、 Precautions

1. The ground wire must be grounded when using. If the mixing rod is not concentric or unstable, please turn off the power supply, adjust the clamp and clamp to make the mixing rod concentric.

2. Medium speed stirring can reduce vibration and prolong service life. The instrument should be kept dry and clean.


}
Video

    No video highlights...
Photo
No photo collection...
Customer
Flash Demo

Project
No related case...
Related articles
Related products
Consulting

Copyright 2020 Changzhou Runhua Electric Co., Ltd. Copyright Design by:EastNet [Manage]
Top