Constant temperature and humidity incubator lhp-200h liquid crystal intelligent program control, welcome to call

1、 Product introduction:

  The structure of the new constant temperature and humidity incubator is made of high-quality cold plate electrostatic spraying plastic. The inner tank is made of high-quality mirror stainless steel and hollow glass. The insulation material is polyurethane foam, with good heat preservation, light weight and beautiful overall appearance. The temperature and humidity control system is controlled by LCD, with accurate and intuitive digital display, high precision, convenient and reliable temperature regulation, and convenient observation. The refrigeration system is a high quality hermetic compressor. The cooling speed is fast and the noise is low. Two high-quality fans are equipped in the box to force the air to convection and the temperature distribution is more uniform. The purpose of the seed incubator is: it is suitable for the cultivation and preservation of bacteria, mold, microorganism, tissue cells, plant cultivation, breeding test, mycology, mold engineering research; the preservation and test of biological products, drugs, vaccine blood and various specimens; it is the production of genetics, medicine, agriculture, forestry, environmental science, animal husbandry, aquatic products, etc And scientific research department of the ideal experimental equipment.

2、 Technical parameters:

1. Effective volume: 200L
2. Temperature control range: 0-50 ℃
3. Temperature control accuracy: ± 0.5
4. Temperature fluctuation range: ± 0.1
5. Heating power: 1000W
6. Power supply voltage: 220V50Hz
7. Working size: length 500 * width 480 * height 850mm
8. Equipped with 3 pallets
9. Refrigeration power: 330W (refrigerant is R134a environment-friendly fluorine-free refrigeration)
10. Humidity fluctuation range: 3% - 5rh%
10. Humidity range: 40% - 95% RH
11. Dimension: 600x650x1460mm

3、 Instructions for use:

1. Turn on the power, close the power switch, the whole machine is powered on, and the power indicator in the switch is on.

2. Please refer to the manual of intelligent digital temperature controller for temperature control setting. Keep dry and ventilated. All switches on the front panel should be in non working state. The experimental samples placed in the incubator should be kept at a proper distance. It is conducive to the convective circulation of cold and hot air. Turn on the power supply, turn on the switch, and the indicator light will be on; if the cultivation temperature is selected and humidity is required, turn on the humidity switch.

3. If lighting is needed, turn on the lighting switch and set the temperature. Press the set key, and the data in the lower row will flash, which means entering the setting state. Press the arrow down key and the set value will decrease. After pressing the set key to the required setting temperature, it means that the working state is entered. The temperature setting is completed and the setting value is increased. Pressing the arrow up key is the same. [see the instrument operation manual for detailed operation instructions]

4. The incubator has the function of power-off protection and a minute and a half delay function. It takes about five minutes for the compressor to start again after shutdown.

4、 Maintenance of incubator:

1. The shell of incubator should be grounded reliably

2. The incubator should be placed in a cool, dry, well ventilated place away from heat sources and sunlight, and placed stably to prevent vibration and noise.

3. In order to ensure the effective heat dissipation of the condenser, the distance between the condenser and the wall should be greater than 10 cm, the side of the box should have a space of 5 cm, and the top of the box should have a space of 30 cm.

4. The incubator should avoid collision, shaking and vibration during handling, repair and maintenance, and the maximum gradient should be less than 45 degrees.

5. If the instrument doesn't work suddenly, please check whether the fuse (behind the box) is burnt out and check the power supply.

No video highlights...