Table centrifuge ld-3 with timing speed regulation 50mlx6, welcome to buy

Ld-3 desktop electric centrifuge

  Ld-3 desktop electric centrifuge is a conventional laboratory centrifuge, widely used in biology, medicine, chemistry and other scientific research, education and production departments. Low speed desktop electric centrifuge with the highest speed of 4000R / min. it can be used for radioimmunoassay identification and separation of cells and large particles. It has a stainless steel liner, which is safer and less noisy.

1、 Ld-3 technical index of desktop electric centrifuge:

2、 Ld-3 desktop centrifuge safety notice: please read all instructions before using ld-3 desktop centrifuge.

1. Before operation, the hollow pipe should be evenly put into the machine, and the machine should be started to run at high speed for 1-2 minutes, and the machine can work only after no abnormality is found. Do not touch the rotating head in operation.

2. It is forbidden to turn the head in the state of unbalanced loading.

3. If the wire or plug is damaged or the electrical equipment fails, it should be repaired by professionals. The use of electrical equipment not recommended by the manufacturer will cause certain quality problems.

4. Do not use in direct sunlight.

5. Do not put the machine near the high temperature heater.

6. The rated parameters of the power socket provided by the user shall be greater than that of the machine, and good grounding measures shall be taken.

7. Never move the machine while it is running.

8. Strong impact is strictly prohibited.

9. When replacing the fuse, the socket should be pulled out from the power supply.

10. When running, the centrifuge cover must be tightly covered to prevent objects from entering and damaging the machine.

11. Keep children away from the machine in use.

12. It is strictly prohibited to use metal scrubbing material for scrubbing, and soft cloth should be dipped in alkali for scrubbing.

3、 Ld-3 desktop electric centrifuge instructions

  The worktable of ld-3 bench type electric centrifuge should be flat and solid, and the workshop should be clean, dry and well ventilated. Before starting up, the inner chamber and the rotating head should be wiped clean, and the corresponding test tubes weighed in advance should be put into the centrifugal hole. Close the centrifuge cover and close the power supply. If there is a timer, set the time first and adjust the speed control knob to increase the required speed. Turn off the power, turn off the power, turn off the power, turn off the power to the minimum position.

Changzhou Runhua Electric Appliance Co., Ltd
Address: No.26, Jinsheng East Road, Jintan City, Jiangsu Province
website: www.runhuayiqi.com
Tel: 0519-82305398
Fax: 0519-823069

No video highlights...